Tail Lamp Iron

Queries and answers about all aspects of modelling the LNWR should be posted here.
Post Reply
murryb
Posts: 168
Joined: Wed Feb 10, 2010 7:09 am
Location: South Island, New Zealand

Tail Lamp Iron

Post by murryb » Fri Jun 19, 2020 8:49 am

What was the size of the lamp irons please. From a drawing I have of 30ft 1inch coach end, I think 7-8 inches high for the part the lamp hangs on and part that bolts on to the carriage 5 inches and how far did they project out. Need to finish D26 cattle wagon, instructions say to fit but does not seem to have a brass etch so will have to make one.

murryb
Posts: 168
Joined: Wed Feb 10, 2010 7:09 am
Location: South Island, New Zealand

Re: Tail Lamp Iron

Post by murryb » Fri Jun 19, 2020 10:09 am

I found it! is on the drawing that was sent to me by Brian and my guess was right 7" high with bottom that bolts on to the carriage 5" and projects
1 3/4" from body with a additional 2" from up right.Must of looked at it 3 or 4 times there is so much info on the drawing Will post a photo later as connection a bit slow.

murryb
Posts: 168
Joined: Wed Feb 10, 2010 7:09 am
Location: South Island, New Zealand

Re: Tail Lamp Iron

Post by murryb » Sat Jun 20, 2020 3:42 am

Lamp iron from Drawing.
Attachments
rsz_1rsz_lamp_iron 2.jpg
rsz_1rsz_lamp_iron 2.jpg (266.44 KiB) Viewed 136 times

Post Reply